forum.zelfbouwaudio.nl

JustinG @ PE schreef:

NEO3-PDRW

Has anyone tested these yet? Are they a drop in for the NEO3-PDR? Or, has anyone tested the NEO3-W? It has much higher sensitivity than the PDRW(93 v. 90.5). I was planning on using the PDR on a project this summer, but since the change over I don't think the FRD and ZMA files I have are correct. I've contacted BG about it and hope to hear something from them.

Chris Brunhaver @ BG schreef:

Hi Justin,

Thanks for the email and your interest in our products! We’re glad to hear that your project with the NEO3PDR worked out well and you plan additional designs with our tweeters.

As for your question, the “W” version is an exact drop in for the old version. The little bit of extra metal and rivet on either side is to assist in the bilateral tensioning of the diaphragms and also to ease sealing to a faceplate.

We have made one small other internal revision to improve consistency but this was seamless as well.

Please let me know if you have any other questions or comments.

Best regards,

Chris Brunhaver

jeroen_d schreef:

-edit- ik denk dat dat bericht van B&G gewoon correct is, daar zou ik op afgaan.

Waar b_force het over heeft, is het verschil tussen de NEO3 en de NEO3PDR. De NEO3 heeft geen vilt op de buitenste sleuven en bundelt daarom meer.